toast

Hi all am looking for a Scalextric chassis to fit this car , must Scalextric as we basically run box stock https://www.alburyrcmodels.com.au/scalex-chevrolet-camaro-1970-57-3612Scalextric C3612

cheers pal

hey all , just got my first difalco controller , i race 24th scale 25k motors and an assorted 32nd scale again up to 25k motors , max voltage 12 volt , so my question do i need a special plug so that i get the full benefit of the controller or just a good old from jaycar be ok cheers shaun

cheers pal

hey all , yup open the bad and all fell out and can't find a single grub screw, i am running 32nd scale rims and just need to know the size of the grub screws so that can get some more cheers in advance

cheers guys

HI all am just wondering if out there , there is good motor tester dyno , its basically so that i know the motor is revving how it should , so i dont have donkey in the back of the car , so nothing flash just can tell me its doing what it should i basically only run 32nd scale cars cheers toast

would that difalco dd304 , handle 25k motors in 24th scale cars you reckon ??

so from this , what would u say is the best difalco to use and with what module ?? i think i am right in that Module ?? part

great post mate , yes its a huge shock to a lot of us thats for sure

cheers ta pal

Cheers

Hi all thoughts on having a test bench am currently looking at this one from the states , but yup alot of money but what are peoples thoughts , over rated or its a must have , maybe not this one but a test bench in general then http://www.slotcarco...ler-test-bench/ cheers toast

cheers guys

hi all very quick question , have an up coming enduro event and are looking at running the SCALEAUTO SC 6005 , but i have to change the motor as not allowed to run the scaleauto , and instead have to run brm short can ,sloit orange endbell, or the nsr shark red motor , would all these fit or not really as dont want to get the car and them spend ages remoulding etc to fit the motor cheers toast